Make: Bracelet Out of Can Pulls

(Adapted from www.funcloud.com)

You Will Need:
- Ring pulls from cans - preferably all the same colour
- Ribbon

Instructions:
(1) Get as many ring pulls as you think you will need to go around your wrist, and a long section of ribbon (don't cut it to fit your wrist just yet)

(2) Thread the first pull onto the ribbon by pushing it up through the smaller hole and down into the larger hole.

(3) Add another, and overlap them:

(4) Keep adding pulls until you think that there are enough on there.

(5) Place over your wrist and line the end up against the rest of the ribbon so that you can see how much to cut.

(6) Cut enough so that you can tie a bow or knot when you wear it.

(7) I recommend tying knots at either end of the pulls to minimise them moving around as much.

(8) Finished! Put it on, and join by tying the ends: